Initial recommended base settings for stage 1 modifications.
GRN @ 5
YEL @ 4
RED @ 3.5
G/B @ 3.5
Y/B @ 4.5
R/B @ 4.5
Controller settings for diagnostic purposes of running 0% change through entire drive cycle. These settings mean your vehicle is running on the stock ECU map.
EJK controllers come with O2 Bypasses OX-005 and OX-009. Your stock O2 connection needs to be disconnected and
the correct bypass installed if O2 present. Some CBR 1000 RR bikes require the male connector and
some require the female connector. You will only use one bypass during the installation.
Main connectors for EJK controller go to the lower / primary injectors. A single connection will install to the upper / secondary injectors
|
0 Items
